Pinball MPU Remote Battery Kit


This kit is for locating the battery away from your pinball MPU board. Moving the battery away from your pinball machine's MPU board will prevent your board from being damaged by corrosion from leaky NiCads. This kit includes: a 3AA battery holder, diode, heat shrink tubing, and enough wire to locate the battery holder at least 2 feet from your MPU board. When you install this, you may use either NiCad batteries, or alkaline batteries. NiCad batteries are what were originally installed on your MPU board, but alkaline batteries will not wick up the wires and corrode your board again. Just install the diode if you intend to use alkaline batteries. An instruction sheet is included to help you with proper hookup.

Special notes: Some knowledge of electronics is necessary for installation of these components, and some soldering is required. Manufacturers may vary, and Gerber Designs reserves the right to substitute parts as needed.


Item # GDKIT-4
Pricing: $4.99
Shipping (United States): $2.99 (plus $0.49 each for additional quantities)
Shipping (Canada): $3.99 (plus $0.69 each for additional quantities)
Shipping (Other International): $5.99 (plus $0.99 each for additional quantities)

 


Click below with shipping to the United States:
Click below with shipping to Canada:
Click below with shipping to Other International:

Back to Kits n Plans

Ordering Information


Copyright 2014 © Gerber Designs
All Rights Reserved. Images or data on this website may not be used or duplicated without prior written permission from
Gerber Designs